Exhaust
These "Ram Horn" cast iron manifolds were patterned off the early 1960's Corvette.
They feature the BIG 2 1/2" outlets and have provisions to accept original alternator type brackets. This manifold comes with gaskets & fasteners included. The ports are approximately 1 5/16" side to side & top to bottom with sufficient material to accept porting to your exhaust port size. It is the square port design with rounded corners.
Specify Lt or Rt
$104.99 Cdn ea.
They feature the BIG 2 1/2" outlets and have provisions to accept original alternator type brackets. This manifold comes with gaskets & fasteners included. The ports are approximately 1 5/16" side to side & top to bottom with sufficient material to accept porting to your exhaust port size. It is the square port design with rounded corners.
Specify Lt or Rt
$104.99 Cdn ea.
SSCRA ProTruck Header
1972 - 1987 Chevy Malibu, Monte Carlo,
Pontiac Grand Prix, Olds Cutlass, Buick Regal.
Also Camaro 70 - 81.
Clears side and rear engine mounts.
Motor must be in stock location.
Will Fit straight or angle plug heads.
Will not clear stock manual clutch linkage ball or air-condition box.
Must use short oil filter such as - Wix 51069
$219.99
1972 - 1987 Chevy Malibu, Monte Carlo,
Pontiac Grand Prix, Olds Cutlass, Buick Regal.
Also Camaro 70 - 81.
Clears side and rear engine mounts.
Motor must be in stock location.
Will Fit straight or angle plug heads.
Will not clear stock manual clutch linkage ball or air-condition box.
Must use short oil filter such as - Wix 51069
$219.99
